Before you know it, your mouse will struggle to track on it. But, before you throw it in the trash and order a new one, cleaning a mousepad is actually very easy. All it takes is a few household items and a little TLC. Here, we’ll take you through how to clean a mousepad step-by-step.
Here’s how to clean an iPhone’s charging port Check out how to clean with vinegar without the smell
How to clean a mousepad — Fabric or cloth
Before we go into this DIY method, it’s important to clarify that you should not use it on RGB or wired mousepads. Otherwise, you could end up damaging your mousepad and voiding the warranty. This cleaning method is explicitly for cloth and fabric mousepads. Sponge or brush Microfiber cloth or towels
- First, fill up a bathtub, sink or a large basin with lukewarm soapy water. Do not use hot water as this could melt the adhesive between the cloth and pad.
- Submerge your mousepad in the water.
- Use a brush or sponge to scrub the mousepad. Scrub in circular motions and be careful not to bend the mousepad too much if it has a foam base, or you could risk damaging it. Likewise, don’t scrub too aggressively on the foam side for the same reason.
- Once you’re satisfied that the dirt and stains have been removed, you can drain the water and rinse out the mousepad with fresh warm water. If you have a foam base, you can squeeze the mousepad between your fingers to remove excess soap, but don’t wring it or you could damage it.
- Now that all of the soap is washed out, you can pat your mousepad dry using towels or a microfiber cloth. Press it flat with whichever you choose on both sides to soak up as much as possible.
- Then, leave your mousepad out to dry completely, cloth side down, before reusing. It will need a few hours at least, or ideally overnight.
- Repeat as necessary.
Can I wash my mousepad in the washing machine?
Some mousepads are actually machine-washable — you just need to check the care label to confirm the best settings. If no instructions are given, err on the side of caution and wash your mousepad by hand. If you do use the washer, throw it in with some towels to soften the load and protect it during the cycle.
How to clean an RGB or wired mousepad
Because it’s electronic, an RGB or wired mousepad should not be submerged in water. Instead, follow these steps:
- Make sure it’s fully unplugged and away from any other electronics.
- Soak a fresh microfiber cloth in warm, soapy water, then wring it out as best you can. You want it to be damp, not sodden, but still soapy.
- Wipe the damp cloth across your mousepad and along the sides to remove any dirt. Avoid any ports of openings as you do this as well as the electronics box.
- Rinse the microfiber cloth with fresh water to remove any soap and wring out fully once more.
- Wipe the cloth over the mousepad to remove the residual soap. Keep rinsing and wringing out the cloth and reapplying until all soap is gone.
- Leave your mousepad out to dry completely before using it.
What about rubber and plastic mousepads?
If you own a rubber or plastic mousepad, then you’re in luck! All you need to do is wipe it clean with wet wipes or a damp microfiber cloth. Just make sure it’s completely dry before you use it.
